In this video, Dave shows you how to install Lap Siding.

.

. LP SmartSide lap siding is a great material to work with, because it isn't fragile to work with lik.

In the video, I staple the metal flashing to the head piece then seal the staples when I paint.

.

2) Start the J-channel installation around windows by nailing the bottom section in place with roofing nails. and 3-1/2 in. www.

See that the starter board is level.

Siding can either be blind nailed at the top or face nailed at the bottom. After notching the siding to fit around the bottom of the window, apply sealant under and around the windowsill. Install the next piece so its end butts lightly against the first (Photo 7, inset).

When covering lap siding with vinyl siding, you need to remove the existing siding and external trim from doors and. yahoo.

7 If a run is shorter than a clapboard, the most accurate way to measure is to hold it in place, fit tightly to the corner trim, and mark it in place.

gap where the siding meets the window trim and sill.

gap where the siding meets the window trim and sill. Install Trim.

Sep 24, 2018 · The bottom of the starter strip (the part the bottom panel hooks on to) should be at least 1 in. Whenever you have a question about a specific product it is always better to contact the manufacturer for the correct answer.

and 3-1/2 in.
See that the starter board is level.
Use roofing nails for blind nailing and siding nails for face nailing.

.

Then, use the tape measure to measure the same distance on each of your shiplap boards.

Tape along the bottom of the flap and at the corners with housewrap tape. . .

. . a) Follow manufacturer instructions, using either expanding spray foam or fiberglass insulation. Next, install the casing around the sides and top of the window. Push your bottom trim up into your bead of caulk to create a tight seal.

Feb 20, 2018 · Measure and cut to length the first piece of siding and nail it in place (Photo 7).

ksc36. Field joints in clapboards are inevitable, and they should be scarfed.

Measure the height on the corner from house roof to dormer roof and cut boards to fit.

search.

com/bourbonmoth.

.

Clamp the cutting guide to the siding to be cut, aligning the cut edge of the plywood part of the guide with the chalk line.